1. |
Disconnect the negative (-) battery terminal.
|
2. |
With a flat-head screwdriver, remove the photo sensor (A) from
the center of defrost nozzle after disconnecting the connector (B).
|
3. |
Install in the reverse order of removal.
|
Special Service Tools
Tool (Number and name)
Illustration
Use
Alternator pulley remover wrench
(09373-27000)
Removal and installation of alternator pulley
...
Auto Light Sensor Inspection
In the state of IGN1 ON, when multi function switch module detects auto
light switch on, tail lamp relay output and head lamp low relay output are controlled
according to auto light sensor ...
Installation
1.
Dowel pin of crankshaft setted about 3° with vertical center line.
2.
Align the TDC marks (A) of the CVVT sprockets with the upper su ...