1. |
Remove the front door trim.
(Refer to the Body group - Front door)
|
2. |
Remove the front door latch.
(Refer to the Body group - Front door).
|
3. |
Disconnect the connectors from the actuator.
|
4. |
Check actuator operation by connecting power and ground according
to the table.
Check for continuity between the terminals in each switch position
when inserting the key into the door according to the table
[Without key (4Pin)]
[With key (6Pin)]
|
1. |
Remove the rear door trim.
(Refer to the Body group - Rear door)
|
2. |
Remove the rear door latch.
(Refer to the Body group - Rear door)
|
3. |
Disconnect the connectors from the actuator.
|
4. |
Check actuator operation by connecting power and ground according
to the table.
Check for continuity between the terminals in each switch position
when inserting the key into the door according to the table
|
Thermostat: Troubleshooting
Symptoms
Possible Causes
Remedy
Coolant leakage
•
From the thermostat gasket
Check the mounting bo ...
Anchor Pretensioner (APT) Removal
1.
Disconnect the battery negative cable, and wait for at least thirty
seconds before beginning work.
2.
Remove the seat belt after pushin ...
Rear Shock Absorber Replacement
1.
Remove the rear wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...