Kia Rio: Power Mosfet (FATC) Inspection
| 1. |
Turn the ignition switch ON.
|
| 2. |
Manually operate the control switch and measure the voltage of
blower motor.
|
| 3. |
Select the control switch to raise voltage until high speed.
Specification
|
| 4. |
If the measured voltage is not within specification, substitute
with a known-good power mosfet and check for proper operation.
|
| 5. |
Replace the power mosfet if it is proved that there is a problem
with it.
|
Blower Resistor (MANUAL) Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the connector (A) and then remove the blower resistor
(B) after loosening th ...
Power Mosfet (FATC) Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the connector (A) and then remove the power mosfet
(B) after loosening the m ...
See also:
Fuses
A vehicle’s electrical system is protected from electrical overload damage by
fuses.
This vehicle has 2 fuse panels, one located in the driver’s side panel bolster,
the other in the engine comp ...
Rear Wiper Motor Installation
1.
Install the rubber packing.
2.
Install the rear wiper motor assembly.
Tightening torque :
6.86 ~ 9.81N ...
SRS Control Module (SRSCM) Variant coding
After replacing the SRSCM with a new unit, the “Variant Coding” procedure
must be performed.
1.
...
Copyright © www.kirmanual.com 2014-2024