1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
3. |
Disconnect the connector from the switch.
|
4. |
Check for continuity between the terminals in each switch position
according to the table. If the continuity condition is not normal, replace
the switch.
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
3. |
Disconnect the connector from the switch.
|
4. |
Check for continuity between the terminals in each switch position
according to the table. If the continuity condition is not normal, replace
the switch.
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the rear door trim panel.
(Refer to the BD group - "Rear door")
|
3. |
Disconnect the 8P connector from the switch.
|
4. |
Check for continuity between the terminals in each switch position
according to the table. If the continuity condition is not normal, replace
the switch.
|
Specifications
Item
Specification
Master cylinder
Type
Fixed
Cylinder I.D.
20.64 mm (0.813 in)
Piston stroke
36±1 mm (1.42±0.039 in)
...
Brake Switch Installation
1.
Install is reverse of removal.
...
Specification
HO2S [Bank 1/Sensor 1]
Item
Specification
Heater Resistance (Ω)
2.4 ~ 4.0 [20°C(68°F)]
HO2S [Bank 1/Sensor 2]
A/F Ratio (λ)
...