1. |
Inspection of parts
Each part, when removed, should be carefully on suspected for
malfunction, deformation, damage, and other problems.
|
2. |
Arrangement of parts
All disassembled parts should be carefully arranged for effective
reassembly.
Be sure to separate and correctly identify the parts to be replaced
from those that will be used again.
|
3. |
Cleaning parts for reuse
All parts to be used again should be carefully and thoroughly
cleaned by an appropriate method.
|
1. |
Oil seals
|
2. |
Gaskets
|
3. |
O-rings
|
4. |
Lock washers
|
5. |
Cotter pins (split pins)
|
6. |
Plastic nuts
Depending on their location.
|
7. |
Sealant should be applied to gaskets.
|
8. |
Oil should be applied to the moving components of parts.
|
9. |
Specified oil or grease should be applied to the prescribed locations
(oil seals, etc) before assembly.
|
Removal
•
Use fender covers to avoid damaging painted surfaces.
•
...
Component Location
1. PCB fuse & relay box (Head lamp low/ hi, Fuel pump #1, HAC,
Engine control, Front wiper, Rain sensor, Blower, Cooling fan low/ hi, Horn,
Buglar alarm horn, Start relay)
...
Antenna Installation
1.
Install the roof antenna, then connect the cable and the connector.
2.
Install the rear roof trim.
...