1. |
Remove the radiator cap, wet its seal with engine coolant, then
install it to pressure tester.
|
2. |
Apply a pressure of 93 ~ 123kPa (0.95 ~ 1.25kgf/cm², 14 ~ 19psi).
|
3. |
Check for a drop in pressure.
|
4. |
If the pressure drops, replace the cap.
|
1. |
Wait until engine is cool, then carefully remove the radiator
cap and fill the radiator with engine coolant, then install a pressure
tester on it.
|
2. |
Apply a pressure of 93 ~ 123kPa (0.95 ~ 1.25kgf/cm², 14 ~ 19psi).
|
3. |
Inspect for engine coolant leaks and a drop in pressure.
|
4. |
If the pressure drops, check hoses, the radiator and the water
pump for leakage. If there is no leakage, inspect the heater core, the
cylinder block and the cylinder head.
|
5. |
Remove the tester and reinstall the radiator cap.
|
1. |
Disconnect the fan motor connector from the resistor.
|
2. |
Connect the battery voltage to the "+" terminal and ground to
"-" terminal.
|
3. |
Check the cooling fan motor operates well.
|
35R Clutch Control Solenoid Valve(35R/C_VFS) Description
35R clutch control solenoid valve(35R/C_VFS) is attached to the valve
body. This variable force solenoid valve directly controls the hydraulic pressure
inside the 35R clutch.
...
Instrument cluster
1. Tachometer
2. Turn signal indicators
3. Speedometer
4. Fuel gauge
5. Engine coolant temperature gauge
6.Warning and indicator lights
7. Shift position indicator (A/T) or Manual tr ...
Components
1. Clutch release fork
2. Clutch cover assembly
3. Clutch disk assembly
4. Clutch release bearing
...