[5 Door] |
|
1. |
After loosening the mounting screws, then remove the rear combination
lamp (A).
|
2. |
Disconnect the rear combination lamp connector (A).
|
3. |
After loosening the rear bumper side’s mounting screws, then disconnect
the side’s.
|
4. |
Remove the rear bumper after pull out the rear bumper.
|
5. |
Loosen the rear bumper lower mounting bolts.
|
6. |
Loosen the rear bumper lower mounting clips.
|
7. |
Loosen the rear bumper side mounting screw and clips.
|
8. |
Push the lock pin, disconnect the rear bumper main connector (A).
|
9. |
Remove the rear bumper cover (A).
|
10. |
Installation is the reverse of removal.
|
[4 Door] |
|
1. |
Remove the rear combination lamp service hole (A).
|
2. |
Disconnect the connector (A) and then loosening the rear combination
lamp mounting nuts.
|
3. |
Remove the rear combination lamp (A).
|
4. |
After loosening the mounting clip and screws, then remove the
rear mud guard (A).
|
5. |
After loosening the rear bumper side’s mounting screw, then disconnect
the side’s.
|
6. |
Loosen the rear bumper lower mounting clips.
|
7. |
Loosen the rear bumper lower mounting bolts.
|
8. |
Loosen the rear bumper side mounting screw and clips.
|
9. |
Push the lock pin, disconnect the rear bumper main connector (A).
|
10. |
Remove the rear bumper cover (A).
|
11. |
Installation is the reverse of removal.
|
Emergency starting
Connect cables in numerical order and disconnect in reverse order.
Jump starting
Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm
to yourself or damage to your vehicl ...
Interior
1. Auto Defogging Sensor
2. Photo Sensor
3. Heater & A/C controller (MANUAL)
4. Heater & A/C controller (FATC)
5. In-car Sensor
6. Heater & Blower Unit
7. ...
Power Door Mirror Actuator Inspection
1.
Remove the front door quadrant delta cover.
(Refer to the BD group - "Front door")
2.
Disconnect the power door mirror conn ...