Rear combination lamp (Inside) |
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the trunk trim.
(Refer to the BD group - "Trunk")
|
3. |
Remove rear combination lamp after removing the mounting nuts
(4EA) and disconnecting the connector (A).
|
4. |
Remove the tail lamp bulb (A) and backup lamp bulb (B) after turning
in the counterclockwise direction.
|
5. |
If necessay to remove the bulb, remove the bulb after removing
the trunk trim
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the lamp cover (A).
|
3. |
Remove rear combination lamp after removing the mounting nuts
(3EA) and disconnecting the connector (A).
|
4. |
Remove the tail lamp bulb (A) and backup lamp bulb (B) after turning
in the counterclockwise direction.
|
5. |
If necessay to remove the bulb, remove the bulb after removing
the lamp cover.
|
Rear combination lamp (Outside) |
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove rear combination lamp after removing the mounting nuts
(4EA) and disconnecting the connector (A).
|
3. |
Remove the turn signal lamp bulb (A) and tail/ stop lamp bulb
(B) after turning in the counterclockwise direction.
|
4. |
If necessary to remove the bulb, remove the bulb after pulling
the trim cover aside.
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the rear combination lamp (A) after removing the mounting
screws.
|
3. |
Disconnect the rear combination lamp connector (A).
|
4. |
Remove the turn signal lamp bulb (A) and tail/ stop lamp bulb
(B) after turning in the counterclockwise direction.
|
5. |
If necessary to remove the bulb, remove the bulb after pulling
the trim cover aside.
|
Electrical System
1.
Be sure to disconnect the battery cable from the negative (-)
terminal of the battery.
2.
Never pull on the wires when disconnecting con ...
Input/ Output Description
Function
I/O
Connector No
Description
Active
Remark
Power
B+
A1
Supply power to BCM
Power
...
A/C Pressure Transducer Inspection
1.
Measure the pressure of high pressure line by measuring voltage
output between terminal “1” and “2”.
2.
Inspect the voltage valu ...