|
1. |
Remove the following items :
|
2. |
Carefully move the glass (A) until the glass mounting bolts are
visible, then loosen them.
[5 Door]
[4 Door]
|
3. |
Check that the glass moves smoothly.
|
|
1. |
Check that the door and body edges are parallel.
[5 Door]
[4 Door]
|
2. |
Place the vehicle on a firm, level surface when adjusting the
doors.
|
3. |
Adjust at the hinges (A) :
[5 Door]
[4 Door]
|
4. |
Grease the pivot portions of the hinges indicated.
|
5. |
Check for water leaks.
|
1. |
Loosen the screws (B) just enough for the striker to move.
|
2. |
Tap on the striker with a plastic hammer to adjust the striker.
The striker will not move much, but will give some adjustment.
|
3. |
Hold the outer handle out, and push the door against the body
to be sure the striker allows a flush fit. If the door latches properly,
tighten the screws and recheck.
|
Schematic Diagram
Canister
The Canister is filled with charcoal and absorbs evaporated fuel vapor
from the fuel tank. The gathered fuel vapor in canister is drawn into the intake
manifold by the ECM/PC ...
Muffler: Removal and Installation
1.
Disconnect the battery negative terminal.
Tightening torque
Without battery sensor :
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ ...
Heated Steering wheel Inpection
1.
Measure a resistance of NTC and Heated pad.
A.
NTC resistance(Black / Yellow, Black) - 10.0 kΩ ± 10%
(25°C(77°F))
...