1. |
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
|
2. |
Remove the front bumper cover. (Refer to the Body group- Front
bumper)
|
3. |
Connect positive (+) and negative (-) battery cables to terminals
3 and 2 respectively to see that the washer motor runs and water is
pumped.
|
4. |
Check that the motor operates normally.
Replace the motor if it operates abnormally.
1. Front washer (+)
2. Ground
3. Rear washer (-)
|
Components
1. Guide rod bolt
2. Bleed screw
3. Caliper carrier
4. Caliper body
5. Brake pad
6. Pad retainer
...
Sub Frame Replacement
1.
Remove the front wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Delivery Pipe Removal
In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be inju ...