Kia Rio: Rear Washer Switch Inspection
| 1. |
With the rear wiper & washer switch in each position, make sure
that continuity exists between the terminals below. If continuity is
not as specified, replace the multifunction switch.
Rear Wiper Switch
Rear Washer Switch
|
Rear Wiper Motor Inspection
Rear Wiper Motor
1.
Remove the 4P connector from the rear wiper motor.
2.
Connect battery positive (+) and negative (-) cables to terminals ...
Rear Washer Motor Inspection
1.
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
2.
Remove the front bumper cover. (Refer to t ...
See also:
Installation
•
Install the component with the specified torques.
•
...
Air bag collision sensors
(1) SRS control module
(2) Front impact sensor
(3) Side impact sensor
WARNING - Air bag sensors
Do not hit or allow any objects to impact the locations where air bag
or sensors are installed ...
Driver's and passenger's front air bag
Your vehicle is equipped with an Advanced Supplemental Restraint (Air Bag) System
and lap/shoulder belts at both the driver and passenger seating position.
The indications of the system's prese ...
Copyright © www.kirmanual.com 2014-2024