1. |
Measure the output voltage between the terminal of the wheel speed
sensor and the body ground.
|
2. |
Compare the change of the output voltage of the wheel speed sensor
to the normal change of the output voltage as shown below.
|
Inspection
[Rotor]
1.
Check that there is continuity between the slip rings (C).
2.
Check that there is no continuity between the slip ...
Thermostat: Installation
1.
Place the thermostat in the block.
Install the thermostat (B) with the jiggle valve upward.
2.
Install the water inlet fitting (A).
...
Component Location
1. Head cap
2. Nut
3. Rear wiper arm & Blade
4. Packing (rubber)
5. Rear wiper motor assembly
6. Bolt
...