Kia Rio: Rear Wiper Motor Inspection
Rear Wiper Motor
| 1. |
Remove the 4P connector from the rear wiper motor.
|
| 2. |
Connect battery positive (+) and negative (-) cables to terminals
4 and 1 respectively.
|
| 3. |
Check that the motor operates normally. Replace the motor if it
operates abnormally.
|
Automatic Stop Operation Check
| 1. |
Operate the motor at low speed using the stalk control.
|
| 2. |
Stop the motor operation anywhere except at the off position by
disconnecting terminal 3.
|
| 3. |
Connect terminals 2 and 3.
|
| 4. |
Connect the positive (+) lead from the battery to terminal 1 and
the negative (-) lead to terminal 4.
|
| 5. |
Check that the motor stops running at the off position.
|
Rear Wiper Motor Installation
1.
Install the rubber packing.
2.
Install the rear wiper motor assembly.
Tightening torque :
6.86 ~ 9.81N ...
Rear Washer Switch Inspection
1.
With the rear wiper & washer switch in each position, make sure
that continuity exists between the terminals below. If continuity is
not as specified, replace t ...
See also:
Audio Unit Removal
•
Take care not to scratch the center fascia panel and related
parts.
...
Spark Plug: Cleaning
The combustion temporarily becomes unstable, due to the aged fuel and
the carbon deposits accumulated on the spark plug(s) after long-term storage.
[1st Method]
1.
...
Dimensions Projected
1.
These are the dimensions measured when the measurement points
are projected from the vehicle's surface, and are the reference dimensions
used for used for body ...
Copyright © www.kirmanual.com 2014-2024