Kia Rio: Reassembly

Disassembly

1. Remove the rear cover (A) after removing nuts. 2. Remove the mounting bolts (A) and the brush holder assembly (B). ...

Inspection

[Rotor] 1. Check that there is continuity between the slip rings (C). 2. Check that there is no continuity between the slip ...

See also:

Steering Gear box Components
1. Tie-rod end 2. Lock nut 3. Bellows clip 4. Bellows 5. Tie rod 6. Rack bar 7. Dust packing 8. Dust cap 9. Oil seal 10. Pinion plug 11. Pinion assembl ...

Anchor Pretensioner (APT) Installation
1. Remove ignition key from the vehicle. 2. Disconnect the negative (-) cable from battery and wait for at least thirty seconds. ...

Description
Fuel Pressure Regulator Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on various engin ...