Kia Rio: Removal
Wiper and Washer Switch
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the steering wheel.
(Refer to the ST group - "Steering column & shaft")
|
| 3. |
Remove the steering column upper (A) and lower (B) shrouds after
removing the screw.
|
| 4. |
Disconnect the connector(A). Release the lock of wiper switch
using tool without removing the steering wheel and the clock spring.
Remove the wiper and washer switch.
|
Multifunction Switch Assembly
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the steering wheel.
(Refer to the ST group - "Steering column & shaft")
|
| 3. |
Remove the steering column upper and lower shrouds after removing
3 screws.
|
| 4. |
Remove the clock spring.
(Refer to the RT group - "Airbag module")
|
| 5. |
Disconnect the lighting switch connector and wiper & washer switch
connector.
Remove the multifunction switch assembly (A) after loosening 2
mounting screws.
|
Inspection
Lighting Switch Inspection
With the multifunction switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified, replace
the mul ...
Installation
Multifunction Switch
1.
Install the multifunction switch.
2.
Install the clock spring.
3.
Install the steer ...
See also:
Fuel Tank Installation
1.
Installation is reverse of removal.
Fuel tank band installation
nut:
39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
...
Driving your vehicle
Be sure the exhaust system does not leak.
The exhaust system should be checked whenever the vehicle is raised to change
the oil or for any other purpose. If you hear a change in the sound of the ex ...
Rear Coil Spring Inspection
1.
Check the coil spring for crack and deformation.
2.
Check the coil spring pad for damage and deformation.
...
Copyright © www.kirmanual.com 2014-2024