1. |
Remove the under cover.
|
2. |
Remove the mounting nut and disconnect the horn connector, then
remove the horn (A).
|
Rear Washer Switch Inspection
1.
With the rear wiper & washer switch in each position, make sure
that continuity exists between the terminals below. If continuity is
not as specified, replace t ...
Dimensions Projected
1.
These are the dimensions measured when the measurement points
are projected from the vehicle's surface, and are the reference dimensions
used for used for body ...
Rain Sensor Installation
•
In case of the windshield with reflection layer which
reflects the infrared rays in se ...