Kia Rio: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the crankshaft position sensor connector (A) and remove
the sensor (B) after removing the installation bolt.
|
Inspection
1.
Check signal waveform of CKPS and CMPS using a GDS.
Specification:
Refer to “Waveform”
...
Installation
•
Install the component with the specified torques.
•
...
See also:
A/C Pressure Transducer Description
The A/C Pressure Transducer (APT) convert the pressure value of high pressure
line into voltage value after measure it. By converted voltage value, engine
ECU controls cooling fan by operatin ...
Specification
Item
Specification
Coil Resistance (Ω)
1.5 [20°C(68°F)]
...
Turn Signal Lamp (Door mirror) Installation
Door Mirror Turn Signal Lamp
1.
Install the door mirror turn signal lamp to the door mirror.
2.
Install the door mirror.
...
Copyright © www.kirmanual.com 2014-2024