1. |
Remove the following items;
|
2. |
Remove the ground line after removing the bolt (A).
|
3. |
Dissconnect the solenoid valve connector (A) and inhibitor switch
connector (B).
|
4. |
Remove the control cable (C) after removing the nut (A) and the
bolt (B).
|
5. |
Disconnect the hose (B) after removing the automatic transaxle
fluid cooler hose clamp (A).
|
6. |
Remove the wiring mounting bolt (A).
|
7. |
Remove the solenoid valve connector and inhibitor switch connector
wiring mounting bracket (A).
|
8. |
Using the engine support fixture (Support SST No.: 09200-2S200,
Adapter SST No.: 09200-1P000, 4X000, Beam SST No.: 09200-38001/3N000),
hold the engine and transaxle assembly safely.
|
9. |
Remove the automatic transaxle upper mounting bolt (A-2ea) and
the starter motor mounting bolt (B-2ea).
|
10. |
Remove the mounting cover (A).
|
11. |
Remove the support bracket mounting bolts (A).
|
12. |
Remove the automatic transaxle support bracket (A).
|
13. |
Lift the vehicle with a jack.
|
14. |
Remove the under cover (A).
|
15. |
Remove the drive shaft assembly.
(Refer to "Drive shaft assembly" in DS group.)
|
16. |
Remove the drive shaft cover (A).
|
17. |
Remove the dust cover (A).
|
18. |
Remove the torque converter mounting bolt (A-4ea) with rotating
the crankshaft.
|
19. |
Remove the roll rod bracket (C) after removing bolt (A,B).
|
20. |
Remove the automatic transaxle with a jack after removing the
mounting bolt (A-2ea, B-3ea).
|
Electric Oil Pump: Installation
1.
Installation is the reverse of removal.
...
Description
Continuous Variable Valve Timing (CVVT) system advances or retards the
valve timing of the intake and exhaust valve in accordance with the ECM control
signal which is calculated by the engine ...
Steering Angle Sensor (MDPS Only) Description
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power
Steering) and it sends messages to HECU through CAN communication line.
The SAS is used to determine turning directio ...