1. |
Turn ignition switch OFF, and disconnect the negative (-) battery
cable.
|
2. |
Remove the battery and ECM.
(Refer to Engine Electrical group - "Battery")
|
3. |
Remove the master cylinder.
(Refer to Master cylinder.)
|
4. |
Disconnect the vacuum hose (A) from the brake booster.
|
5. |
Remove the snap pin (A) and clevis pin (B).
|
6. |
Remove the brake booster mounting nuts (A).
|
7. |
Disconnect the brake tubes (A) from the HECU by unlocking the
nuts counterclockwise with a spanner.
|
8. |
Loosen the brake tube bracket mounting nuts (B).
|
9. |
Pivot the brake tubes (A) down out of the way.
|
10. |
Remove the brake booster (B).
|
Back-up Lamp Switch Inspection
1.
Disconnect the back up lamp switch connector (A).
2.
Check the continuity between no. 1 and 2 terminals of backup lamp
switch. W ...
Components
...
Description
Accelerator Position Sensor (APS) is installed on the accelerator pedal
module and detects the rotation angle of the accelerator pedal. The APS is one
of the most important sensors in engine ...