1. |
Turn ignition switch OFF, and disconnect the negative (-) battery
cable.
|
2. |
Remove the battery and ECM.
(Refer to the Engine Electrical group - "Battery")
|
3. |
Disconnect the brake fluid level switch connector (A) from the
reservoir.
|
4. |
Remove the brake fluid from the master cylinder reservoir with
a syringe.
|
5. |
Disconnect the brake tube from the master cylinder by loosening
the tube flare nut (A).
|
6. |
Remove the clutch hose. [MT Only]
|
7. |
Remove the master cylinder (B) from the brake booster after loosening
the mounting nuts (C).
|
Replacement
The injector combustion seal should be replaced new one to prevent leakage
after removing the injector.
1.
Remove the combustion seal (A) with a wire cutter.
...
Front Wiper Motor Installation
1.
Install the wiper motor.
2.
Install the crank arm.
3.
Install the lower and upper linkage to the wiper motor ...
Room Lamp Installation
Room Lamp
1.
Install the room lamp assembly after connecting the room lamp
connector.
2.
Install the room lamp lens.
...