1. |
Disconnect the brake fluid level switch connector, and remove
the reservoir cap.
|
2. |
Remove the brake fluid from the master cylinder reservoir with
a syringe.
|
3. |
Remove the wheel & tire.
|
4. |
Loosening the tube flare nut (B).
[Front]
[Rear]
|
5. |
Disconnect the brake tube by remove the brake hose clip (A).
|
6. |
Disconnect the brake hose from the brake caliper by loosening
the bolt (A).
[Front disc brake]
[Rear Disc brake]
|
Valve Body Installation
1.
Installation is the reverse of removal.
After replacement or reinstallation procedure of ...
Rear Wiper Motor Installation
1.
Install the rubber packing.
2.
Install the rear wiper motor assembly.
Tightening torque :
6.86 ~ 9.81N ...
Operation Condition for the ISG function
1. Auto stop or Auto start condition
(If all of the below condition are satisfied)
Items
State
Remark
Driving conditions
ISG OFF Switch
...