Kia Rio: Removal
| 1. |
Remove the front wheel & tire.
|
| 2. |
Loosen the hose eyebolt (C) and caliper mounting bolts (B), then
remove the front caliper assembly (A).
|
| 3. |
Remove the front brake disc by loosening the screws (A).
|
Components
1. Guide rod bolt
2. Bleed screw
3. Caliper body
4. Caliper carrier
5. Inner pad shim
6. Brake pad
7. Pad retainer
...
Replacement
Front Brake Pads
1.
Remove the brake hose mounting bracket bolt (A).
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ...
See also:
Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Specifications
Direct control VFS[35R/C]
▷ Control type : Normal low type
Control Pressure kpa (kgf/cm², psi)
500.14 ~ 9.81 (5.1 ~ 0.1,72.54 ~ 1.42)
Current value(mA ...
Special driving conditions
Hazardous driving conditions
When hazardous driving conditions are encountered such as water, snow, ice, mud,
sand, or similar hazards, follow these suggestions:
Drive cautiously and allow extr ...
On-vehicle Inspection
Inspect ignition coil assembly and
Perform spark test
1.
Check for DTCs.
...
Copyright © www.kirmanual.com 2014-2024