1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Remove the resonator and the air intake hose (Refer to “Intake
And Exhaust System” in EM group).
|
3. |
Disconnect the ETC module connector (A).
|
4. |
Disconnect the coolant hoses (A).
|
5. |
Remove the installation bolts, and then remove the ETC module
(A) from the engine.
|
Rear Door Adjustment
Glass Adjustment
•
Check the glass run channel for damage or deterioration,
and repl ...
Troubleshooting
Trouble Symptom
Probable cause
Remedy
Vehicle pulls to one side
Scoring of driveshaft ball joint
Replace
Wear, rattle or scoring of wheel b ...
Fuel Filler Cap
Description
A ratchet tightening device on the threaded fuel filler cap reduces the
chances of incorrect installation, which seals the fuel filler. After the gasket
on the fuel filler cap an ...