Kia Rio: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the manifold absolute pressure sensor connector (A).
|
| 3. |
Remove the installation bolt (B), and then remove the sensor from
the surge tank.
|
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
Spe ...
Installation
•
Install the component with the specified torques.
•
...
See also:
Mirror Replacement
Outside Rear View Mirror Replacement
•
When prying with a flat-tip screwdriver, wrap it wit ...
Smart key
With a smart key, you can lock or unlock a door and even start the engine without
inserting the key.
The functions of the buttons on a smart key are similar to the remote keyless
entry. (Refer ...
Troubleshooting
Problem Symptoms Table
Use the table below to help you find the cause of theproblem. The numbers
indicate the priority of the likecause of the problem. Check each part in order.
...
Copyright © www.kirmanual.com 2014-2024