Kia Rio: Removal
|
| [Bank 1 / Intake] |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the camshaft position sensor connector (A).
|
| 3. |
Remove the installation bolt (B), and then remove the sensor.
|
| [Bank 1 / Exhaust] |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the camshaft position sensor connector (A).
|
| 3. |
Remove the hanger and the protector.
|
| 4. |
Remove the installation bolt (B), and then remove the sensor.
|
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification:
Refer to “Wave Form”
...
Installation
•
Install the component with the specified torques.
•
...
See also:
Front Wheel Speed Sensor Removal
1.
Remove the front wheel and tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
...
Circuit Diagram
(M/T)
(A/T)
...
Removal
1.
Turn ignition switch OFF.
2.
Remove the crash pad lower panel.
(Refer to the Body group - "Crash pad")
...
Copyright © www.kirmanual.com 2014-2024