1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Remove the intake manifold (Refer to “Intake And Exhaust System”
in EM group).
|
3. |
Disconnect the injector connector (A).
|
4. |
Remove the installation bolt (B), and then remove the sensor from
the cylinder block.
|
Transaxle Control Module (TCM) Terminal Function
Connector [EGGG-AA]
Pin
Description
Pin
Description
22
Shift solenoid D (VFS-OD)
73
Inhibitor switch signal "S4"
...
Washer fluid
Checking the washer fluid level
Check the fluid level in the washer fluid reservoir and add fluid if necessary.
Plain water may be used if washer fluid is not available.
However, use washer sol ...
Explanation of scheduled maintenance items
Engine oil and filter
The engine oil and filter should be changed at the intervals specified in the
maintenance schedule. If the vehicle is being driven in severe conditions, more
frequent oil an ...