In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be injury caused by
leakage of the high pressure fuel. Before repairing the high pressure
system, be sure to release the residual pressure in fuel line as step
2 in below procedure.
|
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Release the residual pressure in fuel line (Refer to the Fuel
Delivery System - Repair Procedures - "Release Residual Pressure in
Fuel Line").
|
3. |
Remove the delivery pipe & injector assembly (Refer to "Delivery
Pipe" in this group).
|
4. |
Remove the connector (A) and the fixing clip (B), and then separate
the injector from the delivery pipe.
|
Child-protector rear door lock
The child safety lock is provided to help prevent children from accidentally
opening the rear doors from inside the vehicle. The rear door safety locks should
be used whenever children are in the ...
Filler-Neck Assembly Removal
1.
Open the fuel filler door, and then remove the filler-neck assembly
mounting screws (A).
2.
Disconnect the fuel filler hose (A) ...
Front Wiper Motor Installation
1.
Install the wiper motor.
2.
Install the crank arm.
3.
Install the lower and upper linkage to the wiper motor ...