1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Lift the vehicle.
|
3. |
Disconnect the canister close valve connector (A).
|
4. |
Disconnect the ventilation hose (B) from the fuel tank air filter
and canister close valve.
|
5. |
Remove the fuel tank air filter assembly after removing a bolt
(A).
|
6. |
Remove the bracket (A) after pulling it.
|
7. |
Release the lever (A) by lifting it up.
|
8. |
Remove the canister close valve (B) from the fuel tank air filter
(C) after rotating it in the direction of the arrow in the figure.
|
Rear Wheel Speed Sensor Inspection
1.
Measure the output voltage between the terminal of the wheel speed
sensor and the body ground.
...
Hazard Lamp Switch Installation
1.
Connect the connectors.
2.
Install the hazard lamp switch.
3.
Connect the negative (-) battery terminal.
...
Components
1. Guide rod bolt
2. Bleed screw
3. Caliper carrier
4. Caliper body
5. Brake pad
6. Pad retainer
...