[USA] |
1. |
Disconnect the negative(-) battery terminal.
|
2. |
Remove the smart key unit (A) after disconnecting the connector
and loosening the mounting nut (1EA) and bolts (2EA).
|
[CANADA] |
1. |
Disconnect the negative(-) battery terminal.
|
2. |
Remove the bracket (A) after loosening the bolts (2EA).
|
3. |
Remove the smart key unit (A) after disconnecting the connector
and loosening the mounting nut (1EA) and bolts (2EA).
|
|
1. |
Disconnect the negative(-) battery terminal.
|
2. |
Remove the heater & A/C controller..
(Refer to the HA group - "Controller")
|
3. |
Remove the interior 1 antenna (A) after disconnecting the connector
and loosening the nuts (2EA).
|
1. |
Disconnect the negative(-) battery terminal.
|
2. |
Remove the console.
(Refer to the BD group - "Console")
|
3. |
Disconnect the interior 2 antenna connector, then remove the interior
2 antenna (A) after loosening nuts (2EA).
|
1. |
Disconnect the negative(-) battery terminal.
|
2. |
Remove the trunk transverse trim (A).
|
3. |
Disconnect the trunk antenna connector (A) and remove the trunk
antenna (B) after loosening nuts (2EA).
|
1. |
Disconnect the negative(-) battery terminal.
|
2. |
Remove the rear bumper.
(Refer to the BD group - "Rear bumper")
|
3. |
Disconnect the antenna connector (B) and remove the exterior bumper
antenna (A) after loosening the screws (2EA).
|
1. |
Disconnect the negative(-) battery terminal.
|
2. |
Remove the left side wheel guard.
|
3. |
Remove the external buzzer (A) after disconnecting the connector.
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front door module.
(Refer to the BD group - "Front door")
|
3. |
After loosening the mounting bolt, then remove the outside handle
cover (A).
|
4. |
Remove the outside handle (A) by sliding it rearward.
|
5. |
Disconnect the outside handle connector.
|
1. |
Disconnect the negative(-) battery terminal.
|
2. |
Remove the trunk door trim.
(Refer to the BD group - "Trunk")
|
3. |
Disconnect the trunk lid open switch connector (A).
|
4. |
Remove the trunk open switch (A) from the trunk garnish.
|
Back-up Lamp Switch Inspection
1.
Disconnect the back up lamp switch connector (A).
2.
Check the continuity between no. 1 and 2 terminals of backup lamp
switch. W ...
Front Hub / Knuckle Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) fro ...
Brake fluid
Checking the brake/clutch fluid level
Check the fluid level in the reservoir periodically. The fluid level should be
between MAX and MIN marks on the side of the reservoir.
Before removing the r ...