Kia Rio: Power Door Lock Switch Inspection
Driver Door Lock Switch Inspection
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
| 3. |
Disconnect the connector from the power window switch module.
|
| 4. |
Check for continuity between the terminals in each switch position
according to the table.
|
Power Door Lock Actuators Inspection
Front Door Lock Actuator and Switch
1.
Remove the front door trim.
(Refer to the Body group - Front door)
2.
Remove the front door l ...
Power Door Lock Switch Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the front door trim panel.
(Refer to the BD group - "Front door")
...
See also:
35R Clutch Control Solenoid Valve(35R/C_VFS) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor ...
Teaching Procedures
1.
Key Teaching Procedure
Key teaching must be done after replacing a defective ECM or when
providing additional keys to the vehicle owner.
The procedure st ...
Description
The immobilizer system will disable the vehicle unless the proper ignition
key is used, in addition to the currently available anti-theft systems such
as car alarms, the immobilizer system ai ...
Copyright © www.kirmanual.com 2014-2024