1. |
Remove the front door quadrant delta cover.
(Refer to the BD group - "Front door")
|
2. |
Disconnect the power door mirror connector from the harness.
|
3. |
Apply battery voltage to each terminal as shown in the table and
verify that the mirror operates properly.
Side Repeater Lamp
Mirror Heater
With Folding Mirror
|
TPMS Receiver Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents
are as follows:
1.
Connect self-diagnosis connector(16pins) located in the lower
of driv ...
Torque Converter Control Solenoid Valve (T/CON_VFS) Specifications
Direct control VFS[T/CON]
▷ Control type : Normal low type
Control Pressure kpa (kgf/cm², psi)
9.81 ~ 500.14 (0.1 ~ 5.1,1.42 ~ 72.54)
Current value(mA ...
Overhead Console Lamp Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the overhead console lamp lens (B).
3.
After ...