1. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
2. |
Disconnect the connector from the motor.
|
3. |
Connect the motor terminals No.1 and No.2 directly to battery
voltage (12V) and connect the motor terminals No.6 directly to battery
(-). And then check that the motor operates smoothly. If the operation
is abnormal, replace the motor.
[Safety Power Window]
|
4. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction.
If the operation is abnormal, replace the motor.
[General]
|
1. |
Remove the rear door trim panel.
(Refer to the BD group - "Rear door")
|
2. |
Disconnect the 2P connector from the motor.
|
3. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction.
If the operation is abnormal, replace the motor.
|
Inspection
Self Diagnosis With GDS
Smart key system defects can be quickly diagnosed with the GDS. GDS operates
actuator quickly to monitor, input/output value and self diagnosis.
The following thr ...
Operation
Function Of Safety Power Window
When all door (Front, Rear) power window auto-up switch is operated, safety
function is activated.
1.
Safety function condition
...
Ignition Coil: Inspection
1.
Measure the primary coil resistance between terminals (+) and
(-).
Standard value:
0.75Ω ± 15%
...