1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
3. |
Disconnect the connector from the switch.
|
4. |
Check for continuity between the terminals in each switch position
according to the table. If the continuity condition is not normal, replace
the switch.
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
3. |
Disconnect the connector from the switch.
|
4. |
Check for continuity between the terminals in each switch position
according to the table. If the continuity condition is not normal, replace
the switch.
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the rear door trim panel.
(Refer to the BD group - "Rear door")
|
3. |
Disconnect the 8P connector from the switch.
|
4. |
Check for continuity between the terminals in each switch position
according to the table. If the continuity condition is not normal, replace
the switch.
|
Troubleshooting
Symptom
Suspect Area
Remedy (Refer to page)
Water leaks from sunroof
Dirt accumulated in drain tube
Clear dirt inside of drain
Clogged drai ...
Inspection
1.
Immerse the thermostat in water and gradually heat the water.
2.
Check the valve opening temperature.
Valv ...
Start/Stop Button Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the Audio.
(Refer to the BE group - "Audio")
3. ...