1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the steering wheel.
(Refer to the ST group - "Steering column & shaft")
|
3. |
Remove the steering column upper (A) and lower (B) shrouds after
removing the screw.
|
4. |
Disconnect the connector(A). Release the lock of wiper switch
using tool without removing the steering wheel and the clock spring.
Remove the wiper and washer switch.
|
Dynamic Damper Installation
1.
Apply soap powder on the shaft to prevent being damaged between
the shaft spline and the dynamic damper.
2.
Install the dynamic damper.
...
Heated Steering wheel System Circuit Diagram
Terminal Function
Housing
Pin
Function
Wire color
Pad
A
GND
Back
B
HEATER
Yellow
C
...
Front Wheel Speed Sensor Inspection
1.
Measure the output voltage between the terminal of the wheel speed
sensor and the body ground.
...