The rain sensor may not operate properly if contaminated. Protect
the rain sensor surface by not removing the cover until installation
time. The coupling pad on the rain sensor surface has adhesive strength.
Take care when installing the sensor. If the sensor is separated from
the windshield by force, the sensor or windshield may be damaged. Take
care when removing the sensor.
|
1. |
Remove the rain sensor cover (A) first.
Be careful not to damage the cover latch by applying excessive
force. To remove the latch, pull aside the latch using the cover hole
(B) with the little (-) screwdriver (C).
|
2. |
Remove the wiring harness connector (D) from sensor.
|
3. |
Rain sensor module is attached to the front windshield by glue
replacing the front windshield, remove the rain sensor module from the
existing front windshield and install on the new front windshield.
|
Inspection
Front Door Lock Actuator and Switch
1.
Remove the front door trim.
(Refer to the Body group - Front door)
2.
Remove the front door l ...
Description
Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor
and is installed on the surge tank. It senses absolute pressure of the surge
tank and transfers the analog signal propo ...
Special Service Tools
Tool (Number and Name)
Illustration
Use
09568-34000
Crossmember support
Supporting of the crossmember
09568-34000
Ball joint ...