1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the photo & auto light sensor (A) from crash pad upper
side by using screw (-) driver.
|
3. |
Remove the auto light connector.
|
Compressor Installation
1.
Make sure of the length of compressor mounting bolts, and then
tighten it with the specified tightening order.
Tightening torque :
...
BCM connectors
Pin No.
Connector A
Connector B
Connector C
1
Battery (+)
K_LINE
Turn signal switch (RH)
2
Ignition 2
Centr ...
Rear combination lamp Removal
Rear combination lamp (Inside)
[4 Door]
1.
Disconnect the negative (-) battery terminal.
2.
Remove the trunk trim.
(Ref ...