Kia Rio: Immobilizer Control Unit Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
|
| 3. |
Disconnect the connector of the immobilizer unit and then remove
the immobilizer unit (A) after loosening the bolt.
[USA]
[CANADA]
|
Limp Home Function
1.
Limp Home By Tester
If the ECM detects the fault of the Immobilizer or transponder,
the ECM will allow limp home function of the immobilizer. Limp home
is o ...
Immobilizer Control Unit Installation
1.
Install the immobilizer unit.
2.
Connector the immobilizer unit.
3.
Install the crash pad lower panel.
...
See also:
Instrument Cluster Removal
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or romover, remove the cluster fascia panel
(A).
...
Compressor Installation
1.
Make sure of the length of compressor mounting bolts, and then
tighten it with the specified tightening order.
Tightening torque :
...
Inspection
1.
Check for DTCs.
•
If a DTC is ...
Copyright © www.kirmanual.com 2014-2024