Kia Rio: Ignition Switch Assembly Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the steering column upper and lower shrouds.
(Refer to the ST group - "Steering column")
|
| 3. |
Disconnect the ignition switch connector (B) and the key switch
connector (A) from under the steering column.
|
| 4. |
If it is necessary to remove the key lock cylinder (A), remove
the key lock cylinder after pushing lock pin with key ACC.
|
Ignition Switch Assembly Inspection
1.
Disconnect the ignition switch connector (B) and key switch connector
(A) from under the steering column.
2.
Check for continui ...
Ignition Switch Assembly Installation
1.
Install the key lock cylinder.
When assembling, the key must be insert ...
See also:
4Door Front Body B
Hood hinge mounting hole (Ø11)
Fender apron upper member tooling hole (Ø6.6)
Engine mounting hole (&O ...
Components
...
Inspection
[System Inspection]
1.
Disconnect the vapor hose from the intake manifold and connect
a vacuum pump to the nipple on the intake manifold.
· At Cold Engine [Engi ...
Copyright © www.kirmanual.com 2014-2024