Problem Symptoms Table |
Symptom |
Suspect Area |
No blower operation |
1. Blower fuse |
2. Blower relay |
|
3. Blower motor |
|
4. Blower resistor, Power mosfet or PWM blower module |
|
5. Blower speed control switch or knob |
|
6. Wire harness |
|
No air temperature control |
1. Engine coolant capacity |
2. Heater control assembly |
|
3. Temperature control actuator or cable |
|
No compressor operation |
1. Refrigerant capacity |
2. A/C Fuse |
|
3. Compressor |
|
4. A/C pressure transducer |
|
5. A/C switch |
|
6. Evaporator temperature sensor |
|
7. Wire harness |
|
8. High CAN |
|
No cool comes out |
1. Refrigerant capacity |
2. Refrigerant pressure |
|
3. Drive belt |
|
4. Compressor |
|
5. A/C pressure transducer |
|
6. Evaporator temperature sensor |
|
7. A/C switch |
|
8. Heater control assembly |
|
9. Wire harness |
|
10. High CAN |
|
11. Temperature control actuator or cable |
|
Insufficient cooling |
1. Refrigerant capacity |
2. Drive belt |
|
3. Compressor |
|
4. Condenser |
|
5. Expansion valve |
|
6. Evaporator |
|
7. Refrigerant lines |
|
8. A/C pressure transducer |
|
9. Heater control assembly |
|
10. High CAN |
|
No engine idle-up when A/C switch ON |
1. Engine ECM |
2. Wire harness |
|
No air inlet control |
1. Heater control assembly |
2. Intake actuator |
|
No mode control |
1. Heater control assembly |
2. Mode control actuator or cable |
|
No cooling fan operation |
1. Cooling fan fuse |
2. Fan motor |
|
3. Blower resistor, Power mosfet or PWM blower module |
|
4. Engine ECM |
|
5. Wire harness |
Installation
1.
Dowel pin of crankshaft setted about 3° with vertical center line.
2.
Align the TDC marks (A) of the CVVT sprockets with the upper su ...
Rear Wheel Speed Sensor Inspection
1.
Measure the output voltage between the terminal of the wheel speed
sensor and the body ground.
...
Flat tire
Jack and tools
The spare tire, jack, jack handle and wheel lug nut wrench are stored in the
luggage compartment.
Remove the luggage under tray out of the way to reach the equipment.
(1) Jack ha ...