1. |
If the compressor is marginally operable, run the engine at idle
speed, and let the air conditioning work for a few minutes, then shut
the engine off.
|
2. |
Disconnect the negative cable from the battery.
|
3. |
Recover the refrigerant with a recovery/charging station.
|
4. |
Remove the RH front tire.
(Refer to SS group - “Front Tire”)
|
5. |
Remove the engine room RH side under cover.
(Refer to EM group - “Engine and Transaxle Assembly”)
|
6. |
Separate the front portion of the front wheel guard (A) from the
wheel house.
|
7. |
Loosen the drive belt.
(Refer to EM group - “Timing Chain”)
|
8. |
Disconnect the suction line (A) and discharge line (B) from the
compressor.
|
9. |
Disconnect the compressor switch connector (A).
|
10. |
Remove the compressor by loosening the mounting bolts.
|
Warning / Caution Label Locations
1. Fan caution
2. Radiator cap caution
3. Battery caution
...
Auto Defogging Sensor (FATC only) Description
The Auto Defogging Sensor is installed on the front windshild glass. The
Auto Defogging Sensor senses moisture on the windshild. The air conditioner
control module receives the signal from th ...
Fuel Filler Cap
Description
A ratchet tightening device on the threaded fuel filler cap reduces the
chances of incorrect installation, which seals the fuel filler. After the gasket
on the fuel filler cap an ...