1. |
Check the plated parts of the disc & hub assembly (A) for color
changes, peeling or other damage. If there is damage, replace the clutch
set.
|
2. |
Check the pulley (B) bearing play and drag by rotating the pulley
by hand. Replace the clutch set with a new one if it is noisy or has
excessive play/drag.
|
3. |
Check operation of the magnetic clutch.
Connect the compressor side terminals to the battery (+) terminal
and the ground battery (-) terminal to the compressor body. Check the
magnetic clutch operating noise to determine the condition.
|
External Control Valve Compressor Inspection (GDS) |
1. |
Connect GDS to the vehicle and select 'Aircon Compressor Test(ECV
type)'
[ECV1]
|
2. |
Make the vehicle ready as the GDS instruction on the monitor.
(Turn off A/C 'switch' only)
[ECV2]
[ECV3]
|
3. |
Check if other DTC codes are found before inspect ECV compressor.
If so, solve that problems first. If not, press 'OK' button to continue.
[ECV4]
|
4. |
Start inspection
[ECV5]
[ECV6]
|
5. |
Check the result of inspection.
[ECV7]
[ECV8]
|
6. |
If the result shows "Check" , click "Check" and follow the instruction.
|
7. |
Inspect ECV again from the first step.
|
Components Operations
ECM (Engine Control Module)
1.
The ECM(PCM) (A) carries out a check of the ignition key using
a special encryption algorithm, which is programmed into the transponder
...
Mode Control Actuator Description
The mode control actuator is located at the heater unit.
It adjusts position of mode door by operating mode control actuator based
on signal of A/C control unit. Pressing mode select switch ...
Rear Wheel Speed Sensor Removal
1.
Remove the rear wheel and tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
...