1. |
Turn the ignition switch ON.
|
2. |
Connect the GDS.
|
3. |
Emit intensive light toward photo sensor using a lamp, and check
the output voltage change.
|
4. |
The voltage will rise with higher intensive light and reduce with
lower intensive light.
|
Component Location Index
Engine Room
1. Receiver Drier
2. Condenser
3. Ambient Temperature Sensor
4. Compressor
5. Discharge Hose
6. Suction & Liquid Tube Assembly
7. Service ...
Cruise Control Switch: Installation
1.
Install in the reverse order of removal.
...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the VIS valve connector.
3.
Measure resistance between VIS valve ...