Kia Rio: Auto Defogging Sensor (FATC only) Inspection
| 1. |
Press the MODE switch more then 4 times within 2 seconds while
pressing the OFF switch.
* For diagnostic procedure, refer to DTC guide.
|
Auto Defogging Sensor (FATC only) Description
The Auto Defogging Sensor is installed on the front windshild glass. The
Auto Defogging Sensor senses moisture on the windshild. The air conditioner
control module receives the signal from th ...
Auto Defogging Sensor (FATC only) Replacement
1.
Remove the auto defogging sensor cover (A).
2.
Disconnect the connector (B) and then remove the auto defogging
sensor (C).
...
See also:
Troubleshooting
•
The battery must be in good condition and fully charged
for this troubleshooting.
...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the injector connector.
3.
Measure resistance between the inject ...
Fluid Service Adjustment Procedure
Oil level Check
A check of ATF level is not normally required during scheduled
services. If an oil leak is ...
Copyright © www.kirmanual.com 2014-2024