Kia Rio: Heater Unit Components
| 1. Shower Duct (Left) 2. Heater Pipe Cover 3. Mode Control Actuator 4. Mode Control Actuator Bracket 5. Defog mode lever (FATC) 6. Mode Control Main Lever (MANUAL) 7. Vent Sub lever 8. Vent Door Lever |
9. Foot Sub Lever 10. Heat Case (Left) 11. Heater Core Assembly 12. Aspirator Hose 13.Temperature Control Actuator 14. Temperature Control Actuator Lever 15. Temperature Door Lever |
| 1. NVH Pad 2. Defog Seal 3. Vent Seal 4. Vent/Defog Door 5. Foot Door 6. Temperature Door 7. Evaporator Temperature Sensor Hole Cover 8. Evaporator Temperature Sensor 9. Heater Lower Case 10. Drain Hose |
11. Heater Case (Right) 12. Blower Resistor (MANUAL) 13. Power Mosfet (FATC) 14. Foot Actuator (With auto defogging system) 15. Cool Box Hose 16. Shower Duct (Left) 17. Flange Seal 18. Evaporator Flange Clip 19. Evaporator Core Cover 20. Evaporator Core |
Heater Unit Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/recycling/charging station.
3.
...
See also:
Component Location
1. Windshield wiper arm & blade
2. Wiper & washer switch
3. Windshield washer hose
4. Windshield wiper motor & linkage
5. Washer motor
6. Washer reservoir
...
Installation
Installation is the reverse of removal.
Canister installation bolt/nut:
19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft)
...
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
...
Copyright © www.kirmanual.com 2014-2024