1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the mode control actuator connector.
|
3. |
Verify that the mode control actuator operates to the defog mode
when connecting 12V to terminal 4 and grounding terminal 3.
Verify that the mode control actuator operates to the vent mode
when connecting in the reverse.
|
4. |
Connect the mode control actuator connector.
|
5. |
Turn the ignition switch ON.
|
6. |
Check the voltage between terminal 6 and 7.
Specification
With auto defogging activated
With auto defogging deactivated
It will feedback current position of actuator to controls.
|
7. |
If the measured voltage is not within specification, substitute
with a known-good mode control actuator and check for proper operation.
|
8. |
Replace the mode control actuator if it is proved that there is
a problem with it.
|
Intake Actuator Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad.
(Refer to BD group - "Crash Pad")
...
Circuit Diagram
(M/T)
(A/T)
...
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the ...