1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the foot connector.
|
3. |
Verify that the foot actuator operates to the open position when
connecting 12V to the terminal 3 and grounding terminal 4.
Verify that the foot actuator operates to the close position when
connecting in the reverse.
|
4. |
Connect the foot actuator connector.
|
5. |
Turn the ignition switch ON.
|
6. |
Check the voltage between terminals 6 and 5.
Specification
With auto defogging activated
With auto defogging deactivated
It will feedback current position of actuator to controls.
|
7. |
If the measured voltage is not within specification, substitute
with a known-good foot actuator and check for proper operation.
|
8. |
Replace the foot actuator if it is proved that there is a problem
with it.
|
Smart key unit Circuit diagram
No.
Connector A(26 pins)
No.
Connector B(16 pins)
No.
Connector C(22 pins)
1
VBAT_LOAD
1
C_CAN_L
1
O_S ...
Replacement
Rear Brake Pads
1.
Loosen the guide rod bolt (B) and then remove the rear caliper
body (A).
Tightening torque:
21.6 ~ 31 ...