Kia Rio: Blower Motor Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad and heater & blower unit assembly.
(Refer to HA group – “Heater Unit”)
|
| 3. |
Disconnect the blower motor connector (A).
|
| 4. |
Remove the blower motor (A) after loosening the screws.
|
| 5. |
Install in the reverse order of removal.
|
Blower Motor Inspection
1.
Connect the battery voltage and check the blower motor rotation.
2.
If the blower motor does not operate well, substitute with a know ...
Blower Resistor (MANUAL) Inspection
1.
Measure the resistance between the terminals.
2.
The measured resistance is not within specification, the blower
resistor must be replac ...
See also:
Passenger Airbag (PAB) Module Removal
1.
Disconnect the battery negative cable and wait for at least thirty
seconds before beginning work.
2.
Remove the glove box housing.
...
Receiver-Drier Replacement
1.
Remove the condenser.
2.
Remove the cap (B) on the bottom of the condenser with L wrench
(A).
Tightening torq ...
Installation
1.
Installation is the reverse of removal.
2.
Use a SST (09580-0U000) when installing the brake caliper assembly.
...
Copyright © www.kirmanual.com 2014-2024