1. |
Measure the resistance between the terminals.
|
2. |
The measured resistance is not within specification, the blower
resistor must be replaced. (After removing the resistor)
|
Airbag Disposal
Special tool required
Deployment tool 0957A-34100A
Before scrapping any airbags or side airbags (including those installed
in vehicle to be scrapped), the airbags or side airbag ...
Signal Waveform
...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the manifold absolute pressure sensor connecto ...