Kia Rio: Blower Resistor (MANUAL) Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Disconnect the connector (A) and then remove the blower resistor
(B) after loosening the mounting screws.
|
| 3. |
Install in the reverse order of removal.
|
Blower Resistor (MANUAL) Inspection
1.
Measure the resistance between the terminals.
2.
The measured resistance is not within specification, the blower
resistor must be replac ...
Power Mosfet (FATC) Inspection
1.
Turn the ignition switch ON.
2.
Manually operate the control switch and measure the voltage of
blower motor.
3.
...
See also:
Input Speed Sensor Installation
1.
Installation is the reverse of removal.
After replacement or reinstallation procedure of ...
Component Location
1. DC/DC converter
...
Copyright © www.kirmanual.com 2014-2024