1. |
Turn the ignition switch ON.
|
2. |
Manually operate the control switch and measure the voltage of
blower motor.
|
3. |
Select the control switch to raise voltage until high speed.
Specification
|
4. |
If the measured voltage is not within specification, substitute
with a known-good power mosfet and check for proper operation.
|
5. |
Replace the power mosfet if it is proved that there is a problem
with it.
|
Installation
1.
Installation is the reverse of removal.
Use a new washer (A) whenever ...
Reassembly
•
Thoroughly clean all parts to be assembled.
•
...
Clutch & Brake Components Location
1. Overdrive clutch (OD/C)
2. One way clutch (OWC)
3. Low & Reverse brake (LR/B)
4. Underdrive brake (UD/B)
5. 26 brake(26/B)
6. 35R clutch (35R/C)
7. Damper c ...